pHluorus FLOOR SAFETY TREATMENT INITIAL TREATMENT DIRECTIONS
pHluorus has been formulated to comply with
the exact requirements of your floor, eliminating the need for a specific dwell
time. The only requirement for extraction and neutralization of the chemical is that
you start the process before the liquid starts drying on the floor.
STEP 1. Application: Pour pHluorus into a
mop bucket and mop directly on the floor. Briskly broom the solution evenly while
being careful not to splash solution on glass or aluminum surfaces. All mopping
should be done backwards so as to not leave mops, buckets, pails or brooms containing pHluorus
on the floor. If application area borders carpet, mop lengthwise along border, then
squeegee away from carpet before extraction.
STEP 2. Extraction: Dry mop residue from floor
and thoroughly rinse mop and bucket with clean water. Fill bucket with clean water
and mop on water and dry mop several times (changing mop water after each sequence). Mopping
is not necessary where floor drains exist. Simply hose residue into drains with a
pressure nozzle, brush with a push broom and repeat process until floor produces no more
"cloudiness" in water. Broom between all rinses. After final rinse,
squeegee all water into drains.
STEP 3. Neutralization: (This step is optional
and only recommended where a temporary surface "chalkiness" is unacceptable due
to appearance considerations) Neutralization is partially accomplished from the water
rinses; the more rinses, the more complete. When dry, a slight chalkiness may appear temporarily
depending upon floor surface composition. Complete neutralization will occur within a few
weeks of repeated cleaning with pHluorus CLEANER. Immediate neutralization can
be accomplished with pHluorus NEUTRALIZER (N-7) which is applied similar to STEP
1.. The use of N-7 will slightly reduce the static coefficient of
friction.
CAUTION: CORROSIVE, CONTAINS MINERAL ACIDS
When using undiluted pHluorus for Initial Treatment (or
any other product which gives off inorganic acid gases), always use an approved respirator
during application. Wear rubber boots and protective clothing. Familiarize
yourself with the precautions on the accompanying Material Safety Data Sheet. Respirators
and protective clothing are not required when using pHluorus CLEANER SOLUTION. Manufacturer
or seller makes no warranty, express or implied, concerning the use of this product other
than for the purpose indicated in these directions. Manufacturer or seller is not
liable for any injury or damage caused by this product due to misuse, mishandling or any
application not specifically described herein.
Copyright 1989,pHluorus Inc., all rights reserved
|